Skip to content
Leland Drywall Repair Co.

(910) 996-0490Open 7 days, 7am–9pm

Set up a visit

Corner bead repair in Leland

Corner bead repair in Leland is about the outside corners of walls: the edges at hallway openings, stair landings and kitchen islands that take hits from vacuums, furniture and moving boxes. Once the metal strip under the compound is bent or the compound around it cracks, the corner starts flaking and the bead shows through.

Call the office

An outside wall corner with cracked, flaking compound and the perforated metal corner bead showing through.

Why corners fail

Most corners in newer Leland homes are finished over a perforated metal bead nailed or crimped to the framing. A hard knock dents the metal, the compound over it loses its grip, and every bump after that breaks off a little more. Framing that is still drying, common in subdivisions built in the last decade, can also loosen the bead's fasteners and crack the compound along the edge.

In damp months a bead that has already been exposed can start to rust. Rust bleeds through paint as an orange line, so a corner that has been open for a while is cut back to clean metal or replaced, never just painted over.

Leland's mix of housing shows up in the corners too. Townhouses and patio homes, like many in Magnolia Greens, tend to have tight hallways where every move-in scrapes the same edges. Larger single-family houses in Brunswick Forest often have open plans with long runs of exposed corners at kitchen islands, half walls and stair openings, and those take the bumps from everyday traffic.

Repair or replace the bead?

Straighten and refinish

A shallow dent with the bead still firm can be tapped back, secured with a few new fasteners and refinished. That is usually two visits.

Cut out a section

A bent, loose or rusting stretch is cut out and a new piece of bead is set in line with the old. Paper-faced bead is often used for the new piece because it holds compound well and resists cracking.

Full-height replacement

When the whole corner is damaged, the bead is replaced floor to ceiling so the line stays straight. Plan on three visits for that.

The visit plan for a corner

  1. Visit oneLoose compound and bent bead come off. New bead is set, checked for straight and given its first coat.
  2. Next visitOnce dry, a second coat widens the edges on both faces of the corner.
  3. Last visitFinish coat, sanding to a crisp edge, primer. Ready for paint the following day.

Keeping a corner in one piece

Corners near the garage door, the stairs and the path from the front door to the kitchen take the most traffic. A clear corner guard can be added after paint if a spot keeps getting hit. Rugs and furniture that sit right at a corner can be pulled back an inch or two once the repair is done. If a corner keeps cracking along its length without being bumped, it is more likely framing movement, and that is worth mentioning when you call so the first visit can check for it.

Corner repair, asked and answered

Can a dented corner just be filled over?

Only if the bead underneath is still tight to the wall. Filling over a loose or bent bead looks fine for a while, then cracks again along the same edge.

Will the new corner match the rest of the wall?

The corner is finished to a crisp edge like the others in the house and primed, so paint can follow. Paint the two faces to their nearest breaks for an even look.

Is rust on the bead a big problem?

Not structurally, but it will bleed through new paint. Rusted sections are cut out and replaced as part of the repair.

Leland corner repairs and the booking form

Related pages cover holes and dents on flat walls or cracks from a house still settling. When you are ready to book, use the request form for a visit, or check the Brunswick and New Hanover towns list if you are outside Leland.

Set up a corner repair visit