Skip to content
Leland Drywall Repair Co.

(910) 996-0490Open 7 days, 7am–9pm

Set up a visit

Drywall seam and tape repair in Leland

Seam and tape repair in Leland is the fix for joints that bubble, peel or show a raised line through the paint. It is a common sight in our damp climate, especially on bathroom ceilings and on walls near doors that open to the outside, and it is usually a two- or three-visit job.

Call the office

What damp air does to joint tape

Bubbles and blisters

Paper tape is held on by the compound underneath it. If that bedding coat was thin, or the air stays humid for weeks, the bond lets go and a blister forms that you can press in with a finger.

A raised ridge along the joint

A line that shows in side light often means the tape has lifted slightly along its length. It is common on ceilings where warm, wet air collects, like over a shower without a strong bath fan.

Cracks that follow the seam

A crack running dead straight along a joint is usually the tape pulling apart, not the board. That is different from the diagonal cracks around doors covered on the crack and pop page.

Seam problems, briefly answered

Can a bubbled seam just be cut and glued back?

Small blisters can sometimes be slit and re-bedded, but if the tape is loose on either side the problem spreads. Cutting back to well-bonded tape gives a joint that stays put.

Does the whole ceiling need to be redone?

Rarely. Only the failed run of tape is replaced. The finish coats are feathered wide so the repair disappears once primed and painted.

Will it happen again?

A properly bedded joint holds up to normal humidity. If a bath fan is missing or weak, though, moisture will keep testing every seam in that room.

Why Leland homes see more of this

Leland is a coastal town with a humid subtropical climate, and summer air here stays heavy for weeks at a stretch. A bathroom without an exhaust fan that vents outside, or a house left closed up with the air off while the owners are away, gives seams the conditions they least like.

The town also has a lot of newer construction. Leland incorporated in 1989 and has grown fast ever since, and with fast building, some joints get a thinner bedding coat than they should. Those are the seams that tend to let go first once a damp summer settles in.

Storm leaks play a part as well. A ceiling that took on a little water during a tropical storm, even one that dried without a stain, can see its tape loosen weeks later. If a seam started bubbling after a storm, say so on the phone, because the first visit should then include a moisture reading before the old tape comes off.

From loose tape to a flat joint

  1. First visitLoose tape is cut out back to where it is well stuck. The joint is cleaned, re-bedded in fresh compound and taped.
  2. Next day or the day afterA fill coat goes on once the bedding coat has dried. In a humid room that can take a full day.
  3. Final visitA wide finish coat, light sanding, texture if needed and a coat of primer.

Readying a Leland bathroom for the first appointment

If the problem is in a bathroom, run the fan for its full cycle after showers for a week before the visit so the joint is dry when the old tape comes off. Note whether the fan actually pulls air; holding a square of tissue up to it is a quick check. A weak fan is worth fixing first, or the new seam will be living in the same conditions as the old one.

Brunswick County seam repairs: next steps

Related pages cover leaks that soak the board itself or diagonal cracks near doors and windows. When you are ready to book, use the office contact form, or check the service area page if you are outside Leland.

Set up a seam repair visit